leaking glass bathroom door

How to Fix a Leaking Glass Bathroom Door in Singapore

Nothing is more annoying than a leaking glass bathroom door. Not only does it look bad, but due to the consistent flow of the water, the floor can get slippery, and mould and mildew can accumulate. Also, the consistent water can damage the floor and other bathroom areas, which may cost you a lot for the repairs and sometimes even the whole upgrade.

Therefore, read this article to learn how to fix a leaking glass bathroom door in Singapore. Also, If you need professional assistance with services related to PVC toilet doors, PD toilet doors, glass toilet doors, etc., LS Toilet Door Singapore is your best choice.

How to fix a leaking Glass bathroom Door in Singapore?

A leaking glass bathroom door in Singapore can cause mildew, mould growth, and slippery floors that could lead to serious injuries. Mold can also be a health hazard when you breathe in it. Therefore, follow this guide to fix a leaking glass bathroom door in Singapore step-by-step:

1. Identify Where the Leak Is Coming From

The first step is to know from where the glass bathroom door leaks. You can check that by having somebody shower in the same bathroom and then stand outside and observe. Carefully check the bottom, middle, and hinges of the door to see if these are where water leaks.  

If the water is coming from the bottom of the glass door of your bathroom, then it’s because of the seal or the alignment of the door. If it’s from the sides, then it may be because of the worn-out sealant.

fix leaking glass bathroom door

2. Replace or Install a Door Seal

Most of the time, the reason for the leaking glass door in the bathroom is the worn-out door seals. These are the seals made up of rubber or silicon that block the water from passing through the gaps.  When they get old, they can wear out, crack, or come loose, which could cause water leakage. 

But the good news is that you can easily replace them, and they’re not so expensive. Buy the matching door seals and then remove the existing one by peeling it off. Then, clean the area with soap and water. Then, install the new door seal properly and check the door to see if it’s working fine and if the water is leaking.

3. Adjust the Door Alignment

Can you close your door properly? If you can’t then it means the issue is with the alignment of it and the water is leaking through the gaps. Overtime, due to the regular use, the door can shift and also the hinges can get loose, leaving up the gaps through which the water can easily seep in. 

To fix the issue, check the screws holding the door in place and then tighten them if they’re loose. If the door alignment is messed up, then loosen the screws, realign the door, and then tighten the screws again. That should fix the glass bathroom door leaking.

4. Apply Waterproof Sealant

If water is leaking from the sides, it could be because of worn-out Sealants. When you install the door, you use the sealants to place the glass, but over time, they can wear out. So, apply waterproof sealants on the sides of the door that block the water completely. 

First, clean the area, removing all the dirt and dust. Then, apply the sealant in a thin, even line along the edges of the door from where the door is leaking. Then, smooth it out using your finger or a plastic tool to get a clear finish. 

The sealant will take 24 hours to dry until you don’t need to take a shower in the bathroom. This will repair a leaking glass bathroom door if there is an issue with the sealant.

5. Install a Water Stopper or Threshold

If the water leaks from under the glass door, then you can stop that by installing a water stopper or threshold.  It’s a small raised barrier at the bottom of the door that prevents the water from flowing out.  It’s usually created of rubber or plastic, and you can attach it with screws or any adhesive to your door.

Firstly, get a water stopper or a threshold from the market. They’re easily available. Then, clean the area, apply the adhesive, and place the water stopper firmly on it. If you’re using the one that requires the screws, then put it by screwing it up.

how to fix leaking glass bathroom door

6. Call a Professional If Needed

All of the above-discussed methods are those you can try at home without professional help. However, if you’ve tried all these methods but the glass bathroom door is still leaking, it’s time to call for professional help. 

Because the issue may be complex due to the warped glass, mistakes during the door installation, and any structural damages. You better not try fixing these yourself. You may make it worse due to a lack of experience and the required tools. This is how to fix a leaking glass bathroom door in Singapore sitting right at your home.

Final Words:

How to fix a leaking glass bathroom door in Singapore? You can easily fix a leaky glass bathroom door by following these steps:

  • Identify Where the Leak Is Coming From
  • Replace or Install a Door Seal
  • Adjust the Door Alignment
  • Apply Waterproof Sealant
  • Install a Water Stopper or Threshold
  • Call a Professional If Needed

Frequently Asked Questions

Replace worn seals, install a door sweep, and fill gaps with waterproof silicone. Ensure the door is aligned correctly to avoid uneven gaps that cause leaks.
For glass doors, adjust hinges for proper alignment, replace damaged seals, or add a water stopper. For wooden doors, apply waterproof sealant along edges or use a draft blocker at the bottom to block water.
Gently remove the old seal, clean the track with soapy water, and let it dry. Press a new waterproof seal into place, ensuring full adhesion. Wait 24 hours before using the shower to let it set.